This unit is used for squeezing fabrics of all cotton, chemical fiber and their blends in open-width after washing or impregnating with processing mediums to maintain a certain liquor content in the fabric for further treatment.

• type：two rollers and vertical type ；
• unit hand：L.H or R.H；
• nominal width(mm)：1600、1800、2000；
• squeeze mode：squeeze in two sides；
• max. linear pressure(N/cm)：400；
• air compressure(Mpa)：0.392
• overall dimension（L×W×H）mm: 2220x600x1765

• this unit consist of cast-iron wallboard frames, rollers, cylinders, etc..
• frames:the two sides are all cast iron, connected by three steel tubes.
• rollers: the upper roller is a driven roller and covered with butyronitrile rubber，it’s diameter is 375mm, TH hardness is A85, the lower roller is a driving roller and covered with S.S.，it’s diameter is350mm, it is fixed on the frame, the driven roller is squeezed by cylinders, and slide up and down. the ends of the rollers are equipped with water-block rings, so as to prevent the liquid from entering the bearings.
• pellicle cylinder ：the outer diameter is 400mm. the inner diameter is 320mm. the diameter of the pellicle is 220mm.